Auteur Sujet: Echolink  (Lu 3154 fois)

Hors ligne VE2BSM Martin

  • Membre junior
  • **
  • Messages: 25
Echolink
« le: 03 Juillet 2008, 00:17:36 »
Bonsoir

Je voudrais me inscrire sur echolink mais je suis perdu la je sais qui faut je envoir mon certificat de radio mais comment  j ai pas de # de fax ou meme pas de e-mail
si quelle q'un pourrais me donner un coup mais svp

je vais sur la page de validatiion
http://www.echolink.org/validation/
je mais les lettre ve2bsm
j ai se message la

Validation - Choose Callsign

The callsign you entered is: VE2BSM


EchoLink can be set up with any of several different callsign suffixes. The callsign VE2BSM (with no suffix) is used in Single-User mode, and the callsigns VE2BSM-L or VE2BSM-R are used in Sysop mode. (Sysop mode requires connecting a radio to your computer's sound card using a special interface device.) Each of these three is considered a separate callsign, and must be validated separately for EchoLink.

There are no validation requests in the EchoLink system right now for VE2BSM.

If you would like to validate this call for use with EchoLink, please download, install, and run the EchoLink software first. This registers your call with the system. Then, return to the Validation page to proceed with validation.

FAQ For This Page
I've installed and run the EchoLink software, but I don't see my callsign in the list above. What's the problem?
Check to see if a "firewall" issue is preventing the EchoLink software from contacting our servers. Also, be sure you are not using an EchoLink Proxy to connect; you cannot register a new callsign through a Proxy connection (although you may use a Proxy after it has been valid


que faire merci
73
ve2bsm
martin

Hors ligne VE9MDB Matthieu

  • Membre guru
  • *****
  • Messages: 1 296
    • Pour me téléphoner...
Re : Echolink
« Réponse #1 le: 03 Juillet 2008, 00:32:44 »
Bonjour Martin,

Tu dois d'abord installer le logiciel Echolink.
Ensuite tu dois t'enregistrer dans le logiciel avec ton callsign.

Une fois que c'est fait, ça va enregistrer ton indicatif dans le système.
Après, tu peux retourner sur le lien qu'ils t'ont donnés et ils vont te donner les étapes à suivre ( y compris le numéro de téléphone où tu peux faxer ta licence ! ).

Bonne chance,

Matt
GRID : FN76ne
Fondateur du Club Radioamateur Université de Moncton (VE9UDM).
Technicien, Université de Moncton.
Tel: 1-514-702-8180

Hors ligne VE2BSM Martin

  • Membre junior
  • **
  • Messages: 25
Re : Echolink
« Réponse #2 le: 03 Juillet 2008, 08:50:22 »
Merci Matthieu

pour les info

martin
73