...
Mon anglais étant ce qu'il est !
si je comprend bien ce texte ..avec le K1 .. on a pas besoin d'appuyer sur un bouton comme le KX3 pour se tuner .. l'appareil le fera seul ?
Basic ATU Operation (TUN)
To tune up an antenna using the KAT1:
• Use the K1 menu to set the ATU’s operating mode to TUN (auto-tune), then exit the menu.
• Connect an antenna and ground to the K1. (You can use most coax-fed antennas, as well as
end-fed wires connected directly to the K1 with no coax. Use a balun with balanced feedlines.)
• Enter TUNE mode. Power will be reduced to about 1.5 watts and displayed briefly, then SWR will be
displayed while the ATU matches the transmitter to the load (usually 1-5 seconds). If the match is
already very good (< 1.2:1), the tuner’s L and C settings will not be changed.
• When you no longer hear any relays switching, tune-up has completed, and the final SWR is
displayed. At this point you can optionally tap WPM+ or WPM- to change the selected power level.
Pressing any other switch or tapping the key will cancel TUNE and restore your specified power.
• ATU settings are stored in EEPROM, and will be recalled instantly whenever you change bands.